Here are the steps to fix a bad tire:

1. Determine the cause of the problem: Before you can fix a bad tire, you need to determine what is causing the problem. Common causes of bad tires include punctures, cuts, and worn treads.
2. Remove the tire from the vehicle: If the tire is flat, you’ll need to remove it from the vehicle. You can do this by loosening the lug nuts with a lug wrench and then using a jack to lift the vehicle off the ground.
3. Repair or replace the tire: Depending on the cause of the problem, you may be able to repair the tire, or you may need to replace it. For small punctures, you can use a tire repair kit to plug the hole. If the damage is too severe, you’ll need to replace the tire.
4. Install the new or repaired tire: Once the tire has been repaired or replaced, you can reinstall it on the vehicle. Make sure the tire is properly seated on the rim, and then tighten the lug nuts securely.
5. Check the tire pressure: After you have installed the new or repaired tire, it’s important to check the tire pressure. Make sure it’s at the recommended level, as indicated in the owner’s manual or on the tire itself.

By following these steps, you can safely and effectively fix a bad tire and get back on the road.

Here are the steps to change a tire:

1. Find a safe place to change the tire: Look for a flat, level surface that is away from traffic. Turn on your hazard lights to warn other drivers.
2. Gather the necessary tools: You’ll need a jack, a lug wrench, and a spare tire. Make sure you have all the tools you need before you start changing the tire.
3. Loosen the lug nuts: Use the lug wrench to loosen the lug nuts on the tire you need to change. Do not remove the nuts yet, just loosen them.
4. Jack up the vehicle: Place the jack under the vehicle’s designated jacking point, which is usually indicated in the owner’s manual. Slowly raise the vehicle until the tire is off the ground.
5. Remove the flat tire: Remove the lug nuts and take off the flat tire. Place the lug nuts in a safe place so you don’t lose them.
6. Mount the spare tire: Line up the holes in the spare tire with the studs on the wheel hub, and then secure the tire with the lug nuts. Tighten the lug nuts as much as you can by hand.
7. Lower the vehicle: Slowly lower the vehicle back to the ground. Use the lug wrench to tighten the lug nuts as much as possible.
8. Check the tire pressure: Check the tire pressure on the spare tire to make sure it’s at the recommended level, as indicated on the tire itself.
9. Drive to a safe location: The spare tire is meant to be temporary, so it’s important to drive to a safe location as soon as possible to have the flat tire repaired or replaced.

By following these steps, you can change a tire quickly and safely.